Terex Amda RL 4000 portable Light Tower

Description

ENGINE
 Kubota® D1105 – liquid cooled, diesel engine
o Standby – 15.4 hp @ 1800 rpm
o Prime – 13.5 hp @ 1800 rpm
o 3 cylinder
o 1.123 L displacement
 Fuel consumption (prime) ~ 0.5 gph
 60 Hz engine/generator
 Industrial engine exhaust system
 Rubber vibration dampers isolate engine/generator from frame
 Cooling system capable of operating at 120°F ambient
 Full flow oil filter, spin on type
 Fuel filter with replaceable element
 Dry type cartridge air filter
 Polyethylene fuel tank with large diameter opening
o 30 gal. capacity
o 60 hr. run capacity
o 3 ½” fill port
ENGINE CONTROLS
 Galvanized control panel located inside cabinet
 Four position keyed switch – glow plugs (preheat, off, run, start)
 Hour meter
 Automatic low oil/high temperature shutdown system
GENERATOR
 Marathon Electric
o Brushless
 6 kW standby output
 120/240 VAC – 20/30A
 +/-6% capacitor voltage regulation
ELECTRICAL SYSTEM AND CONTROLS
 Individual floodlight circuits with 15A breakers
 30A start limit breaker (assures no load condition exists before starting)
 Standard individually breakered convenience outlets:
o (1) 120 VAC 20 Amp GFCI duplex outlets (Nema 5-20R type)
o (1) 240 VAC 30 Amp twistlock outlets (Nema L6-30R type)
 500 CCA wet cell battery

FLOODLIGHTS
 Four light fixtures – 1000 watts each – metal halide
 Round aluminum reflector
 Tempered glass lens
 Silicone gaskets for moisture and dust protection
 Individual floodlight On/Off switches
WIRING
 All wiring is sized to the amperage draw required
 AC & DC wiring diagrams are provided in service manual
MAST
 30’ maximum extension, 3-section, tubular steel
 UHMW glide pads on all sides of mast tubes
 Standard fully galvanized mast sections
 Automatic locking system in horizontal position for travel
 1500 lb. automatic self-braking winches
 359° rotation with locking system
 Retractable coiled mast cord
 Galvanized mast cord protection
 Dual winch system located at ergonomic height allowing single person operation
 Equipped with single lifting eye and fork pockets
ENCLOSURE
 Steel enclosure – 14-gauge
o UV& fade resistant, high temperature cured, white polyester powder paint
 English, English/French, or symbol operating/safety decals
 License plate holder with light
TRAILER
 Mast support – formed ¼” plate
 Removable tongue – 50” long
 Rigid formed steel chassis – 12 gauge
 Four, 2500 lb. adjustable leveling jacks – 4 point stance
 All jacks transport and lock in horizontal position for storage
 Side outriggers – 9’ 8” span
 Safety chains with s-hooks
 2” ball hitch
 Steel fenders – 14 gauge
 DOT approved tail, side, brake, and directional lights
o Recessed rear and side lights
 2000 lb. leaf spring axle
 P175/80D13 tires
 48” axle span